Installing The Water Pump - KTM 450 EXC-R EU Repair Manual

30/ENGINE - WORK ON INDIVIDUAL PARTS

Installing the water pump

Press out bearing
Info
Support the clutch cover as necessary when pressing it out.
200198-10
Check parts for damage and wear. Replace damaged or worn parts.
Press in bearing
Info
Support the clutch cover suitably when pressing it in.
200198-11
Press in shaft seal ring
Info
Spacers
Press in shaft seal ring
spacer .
200197-11
Mount water pump shaft
Info
Do not damage the shaft seal rings.
Mount spacing washer and water pump wheel
200196-11
Mount the drive wheel. Mount lock ring
Mount and tighten nut
Specification
Nut, water-pump wheel
200195-11
of the water pump shaft using a suitable tool.
of the water pump shaft using a suitable tool until it is flush.
fully with the open side facing inwards.
must face outwards.
with the open side facing inwards until it is flush with
.
.
.
M6 6 Nm
(4.43 lbf ft)
.
®
Loctite 648™
77