Restoring The Network Configuration; Sharing The Printer On A Network; Shared Printing - Dell 5330dn User Manual

To enter the TCP/IP address from your printer's operator panel, take the following steps:
1. Press Menu (
2. Press Scroll (
3. Press Scroll (
4. Press Scroll (
5. Press Scroll (
6. The first available menu item, IP Address displays.
7. To enter the numbers, use Scroll (
8. Enter other parameters, such as the Subnet Mask or GateWay, and press Select (
9. After entering all parameters, press Cancel (
Dynamic Addressing (BOOTP/DHCP)
To assign the TCP/IP address automatically using a DHCP or BOOTP server on your network, perform the following steps:
1. Press Menu (
2. Press Scroll (
3. Press Scroll (
4. Press Scroll (
5. Press Scroll (
To assign the address from the BOOTP server, press Select (

Restoring the Network Configuration

You can return the network configuration to its default settings.
1. Press Menu (
2. Press Scroll (
3. Press Scroll (
4. Press Scroll (
5. Power the printer off and back on.
Setting a Wireless network (Optional wireless network card)
To use the Dell 5330dn Mono Laser Printer in both wired and wireless network environments, you can install an optional wireless network card. For details
of Wireless setup, please refer to "Quick Install Guide" for the wireless network interface card.

Sharing the Printer on a Network

Shared Printing

You can use Microsoft's Point and Print or Peer-to-Peer methods to share a printer on the network with a USB or parallel cable connection. To use one of these
methods, you must first share the printer and then install the shared printer on client computers.
However, if you use one of these Microsoft methods, you will not have all the Dell features, such as the Status Monitor, that are installed with the Drivers and
Utilities CD.
NOTE: Windows 2000, Windows XP Professional, Windows NT, and Windows Vista require administrative access to share a printer.
Downloaded from ManualsPrinter.com Manuals
).
to ) to highlight Network I/O Ports and press Select (
to ) to highlight TCP/IP(IPv4) and press Select (
to ) to highlight Set IP Address and press Select (
to ) to highlight Manual and press Select (
to ) and Scroll (
) to return to Standby mode.
).
to ) to highlight Network I/O Ports and press Select (
to ) to highlight TCP/IP(IPv4) and press Select (
to ) to highlight Set IP Address and press Select (
to ) to highlight DHCP and press Select (
).
to ) to highlight Network I/O Ports and press Select (
to ) to highlight Clear Settings and press Select (
to ) to highlight Yes and press Select (
).
).
).
).
to ) to move between octets and press Select (
).
).
).
).
).
) when BOOTP displays.
).
).
).
).