Download  Print this page

Paper Output Capacity; Printer And Paper Storage Environment - Dell 5330dn User Manual

Mono laser printer.
Hide thumbs

Advertisement

Table of Contents
Smoothness

Paper Output Capacity

Output Location
Output tray (Face
Down)
Rear door (Face Up) 100 sheets of 75 g/m

Printer and Paper Storage Environment

 
Paper storage environmental conditions directly affect the feed operation.
 
Ideally, the printer and paper storage environment should be at or near room temperature not too dry or humid. Remember that paper is hygroscopic: it
absorbs and loses moisture rapidly.
 
Heat works with humidity to damage paper. Heat causes the moisture in paper to evaporate, while cold causes it to condense on the sheets. Heating systems
and air conditioners remove most of the humidity from a room. As paper is opened and used, it loses moisture, causing streaks and smudging. Humid weather
or water coolers can cause the humidity to increase in a room. As paper is opened and used, it absorbs any excess moisture causing light print and dropouts.
Also, as paper loses and gains moisture, it can become distorted. This can cause paper jams.
 
Care should be taken not to purchase more paper than can be used in a short time (about 3 months). Paper stored for long periods may experience heat and
moisture extremes, which can cause damage. Planning is important to prevent damage to large supplies of paper.
 
Unopened paper in sealed reams can remain stable for several months before use. Opened packages of paper have more potential for environment damage,
especially if they are not wrapped with a moisture-proof barrier.
 
The paper storage environment should be properly maintained to ensure optimum performance. The required condition is 20° C to 24° C (68° F to 75° F) with
a relative humidity of 4 percent to 55 percent. The following guidelines should be considered when evaluating the paper's storage environment:
 
Paper should be stored at or near room temperature.
l
 
The air should not be too dry or too humid.
l
 
The best way to store an opened ream of paper is to rewrap it tightly in its moisture-proof wrapping. If the printer environment is subject to extremes,
l
unwrap only the amount of paper to be used during the day's operation to prevent unwanted moisture changes.
Downloaded from ManualsPrinter.com Manuals
100-400 Sheffield
2
250 sheets of 75 g/m
bond (20 lb) paper
2
bond (20 lb) paper
Capacity

Advertisement

Table of Contents

   Related Manuals for Dell 5330dn

Comments to this Manuals

Symbols: 0
Latest comments: