Weight Display; Turning The Balance On And Off; On/Off Key - Sartorius M3P Installation And Operating Instructions Manual

Weight Display

The weight display shows the following special
messages for your information:
BUSY
The balance processor is still busy processing a function and
will not accept any other commands to perform functions at this
time.
STANDBY
The display has been turned off with the ON/OFF key (8) and
the balance is now in the ready-to-operate mode so that it does
not require warmup.
POWER OFF
The balance was disconnected from line power (reconnection to
line power after the balance was unplugged; power failure or
outage).
CAL
The calibration function has been activated.
Turning the Display On and Off
Press the ON/OFF key (8) to turn the display on or off.
You can also turn it on by pressing the tare control (12).
After the balance has been connected to the power supply, the
display will go out when ever you turn off the balance using the
ON/OFF key. The LEDs next to the symbols " ~ 750 mg" and
" ~ 1500 mg" below the weight display indicate that the bal-
ance has already arrested the weighing system automatically
(see page 23 "Transporting the Balance" in addition). All other
electronic circuits will remain energized (indicated by
STANDBY). This means the balance is immediately ready to
operate without requiring warmup the next time you turn it on.
13