Startup
Preparing the M3P for Operation
Remove the rubber band from the doors of the weighing cham-
ber. Place the interior draft shield (3) in the weighing chamber.
Use forceps to position the pan support (2) on the draft shield,
and place the weighing pan (1) on the pan support.
Preparing the M3P-OOOV001 Filter Microbalance for Opera-
tion
For weighing filters with diameters ranging up to 70 mm
(~ 2.8 in.):
—
Slightly lift the cover of the weighing chamber and turn it
to the left or to the right
Place the spacer (16) and the interior draft shield (3) in
—
the weighing chamber
—
Use forceps to position the filter pan holder (non-
perforated) (18) and the small pan (19) for filter diameters
up to 70 mm (~ 2.8 in.)
Weighing filters with diameters ranging from 70 to 100 mm
(~ 2.8-3.9 in.):
—
Slightly lift the cover of the weighing chamber and turn it
to the left or to the right
—
Place interior draft shield (3) in the weighing chamber
—
Use forceps to position the perforated filter pan holder
(17) and the large filter weighing pan (20)
Weighing with the standard-size weighing pan
(22 mm Ø = ~ 1" Ø):
—
Slightly lift the cover of the weighing chamber and turn it
to the left or to the right
—
Place the spacer (16) and the inferior draft shield (3) in
the weighing chamber
—
Use forceps to position the pan support (2) and the stan-
dard-size weighing pan (1)
9