Transporting The Balance; Transport Arrestment - Sartorius M3P Installation And Operating Instructions Manual

Transporting the Balance

To transport the balance, the weighing system must be arrested
as described in the following.

Transport Arrestment

Before you unplug the balance from the power supply, turn
off the balance using the ON/OFF key (8). The LEDs next to
the symbols " ~ 750 mg" and " ~ 1500 mg" below the
weight display will now light up, indicating that the weigh-
ing system of the balance is being arrested automatically
for transportation. As soon as the LED's go out, automatic
arrestment of the weighing system has been completed.
Remove the weighing pan (1) or the filter pan (19/20). Use your
fingers to carefully lift the interior draft shield (3) along with the
assembled pan support (2) or filter pan holder (17/18) out of the
weighing chamber. Disassemble the parts and replace then in
the case for the kit of accessories.
Place a rubber band over both knobs of the weighing chamber
doors to prevent then from sliding open when the balance is
transported.
The balance must be conditioned each time you move it to
another location.
23