Notes About This Documentation; Validity Of This Documentation; Copyright; Table 1: Variants - WAGO 750-652 Manual

6

Notes about this Documentation

1 Notes about this Documentation
Always retain this documentation!
This documentation is part of the product. Therefore, retain the documentation
during the entire service life of the product. Pass on the documentation to any
subsequent user. In addition, ensure that any supplement to this documentation is
included, if necessary.
1.1

Validity of this Documentation

This documentation is only applicable to the I/O module 750-652 (Serial Interface
RS-232 / RS-485) and the variants listed in the table below.

Table 1: Variants

Item Number/Variant
750-652
750-652/025-000
Documentation Validity for Variants
Unless otherwise indicated, the information given in this documentation applies to
listed variants.
The I/O module 750-652 shall only be installed and operated according to the
instructions in this manual and in the manual for the used fieldbus
coupler/controller.
Consider power layout of the WAGO-I/O-SYSTEM 750!
In addition to these operating instructions, you will also need the manual for the
used fieldbus coupler/controller, which can be downloaded at www.wago.com.
There, you can obtain important information including information on electrical
isolation, system power and supply specifications.
1.2

Copyright

This Manual, including all figures and illustrations, is copyright-protected. Any
further use of this Manual by third parties that violate pertinent copyright
provisions is prohibited. Reproduction, translation, electronic and phototechnical
filing/archiving (e.g., photocopying) as well as any amendments require the
written consent of WAGO Kontakttechnik GmbH & Co. KG, Minden, Germany.
Non-observance will involve the right to assert damage claims.
750-652 Serial Interface RS-232 / RS-485
Designation
Serial Interface RS-232 / RS-485
Serial Interface RS-232 / RS-485/T
WAGO-I/O-SYSTEM 750
Manual
Version 1.4.0