Connect Devices; Connecting A Conductor To The Cage Clamp - WAGO 750-652 Manual

WAGO-I/O-SYSTEM 750
750-652 Serial Interface RS-232 / RS-485
7

Connect Devices

Use shielded signal lines!
Only use shielded signal lines for analog signals and I/O modules which are
equipped with shield clamps. Only then can you ensure that the accuracy and
interference immunity specified for the respective I/O module can be achieved
even in the presence of interference acting on the signal cable.
7.1

Connecting a Conductor to the CAGE CLAMP

The WAGO CAGE CLAMP
finely stranded conductors.
Only connect one conductor to each CAGE CLAMP
Only one conductor may be connected to each CAGE CLAMP
Do not connect more than one conductor at one single connection!
If more than one conductor must be routed to one connection, these must be
connected in an up-circuit wiring assembly, for example using WAGO feed-
through terminals.
Exception:
If it is unavoidable to jointly connect 2 conductors, then you must use a ferrule to
join the wires together. The following ferrules can be used:
Length:
Nominal cross section
WAGO product:
1. For opening the CAGE CLAMP
above the connection.
2. Insert the conductor into the corresponding connection opening.
3. For closing the CAGE CLAMP
now clamped firmly in place.
Manual
Version 1.4.0
®
connection is appropriate for solid, stranded and
8 mm
2
: 1 mm for 2 conductors with 0.5 mm
max.
216-103 or products with comparable properties
®
insert the actuating tool into the opening
®
simply remove the tool. The conductor is
Connect Devices
®
®
!
®
.
2
each
41