Removal Procedures - Lexmark CX725 Service Manual

8
Repeat step 2 through 7 to make further adjustments.
9
From the Print Quick Test section, touch Start.
10
Place the quick test page facedown on the ADF, and then select Rear ADF Registration.
11
From the Copy Quick Test section, touch Start.
12
Compare the pages from the print quick and copy quick tests.
13
Adjust the value of the horizontal adjust, top margin, horizontal magnification, and vertical magnification
settings.
14
Apply the changes.
15
Repeat step 8 through 14 to make further adjustments.
Flatbed registration adjustment
1
From the home screen, navigate to:
Settings > Device > Maintenance > Configuration Menu > Scanner Configuration > Scanner Manual
Registration
2
From the Print Quick Test section, touch Start.
3
Place the test page on the flatbed, and then select Flatbed Registration.
4
From the Copy Quick Test section, touch Start.
5
Compare the pages from the print quick and copy quick tests.
6
Adjust the value of the horizontal adjust, top margin, horizontal magnification, and vertical magnification
settings.
7
Apply the changes.
8
Repeat steps 2 through 7 to make further adjustments.

Removal procedures

Keep the following tips in mind as you replace parts:
•
Some removal procedures require removing the cable ties. Replace the cable ties during reassembly to
avoid pinching wires, obstructing the paper path, or restricting mechanical movement.
•
Remove the toner cartridges, imaging unit, and media tray before removing other printer parts. The imaging
unit should be carefully set on a clean, smooth, and flat surface. It should also be protected from light while
out of the device.
•
Disconnect all external cables from the printer to prevent possible damage during service.
•
Unless otherwise stated, reinstall the parts in reverse order of removal.
•
When reinstalling a part held with several screws, start all screws before the final tightening.
Repair information
308
7528