Aligner Idler Gears Removal - Lexmark CX725 Service Manual

Installation note: Make sure to replace this screw first before replacing the three screws to secure the
unit.
5
Disconnect the motor cable (C) and sensor cable (D).
6
Tilt the right portion of the isolation unit to the front, and then remove the unit.
7
Route the isolation unit cables out of the printer.

Aligner idler gears removal

1
Remove the imaging kit.
2
Remove the media feeder. See
3
Remove the isolation unit. See
"Media feeder removal" on page
"Isolation unit removal" on page
Repair information
425
422.
423.
7528