Finisher Tests - Lexmark C910 Service Manual

5055-01X
Once the maximum pass count or fail count is reached, the test
stops and final test results display:
Receive Status Interrupt Error, Status Error, Receive Data Interrupt
Error, Transmit Data Interrupt Error, Transmit Empty Error, Threshold
Error, Receive Data Ready Error, Break Interrupt Error, Framing
Error, Parity Error, Overrun Error, Data Error, Data 232 Error, Data
422 Error, FIFO Error, DSR Error, DSR PIO Error, DSR Interrupt
Error, CTS Error, CTS PIO Error, or CTS Interrupt Error.
Once the maximum pass count or fail count is reached, the test
stops and the final test results display. Press Return or Stop to exit
the test.

Finisher Tests

Staple Test
This test verifies the operation of the staple mechanism in the
finisher.
The media is fed from the default paper source. After selecting a
destination bin, the printer feeds eight pieces of media and
accumulates them in the finisher accumulator. The printer prints an
alignment pattern during this test. After the last sheet is
accumulated, the eight sheets are stapled and fed to bin 2.
The staple test cannot be canceled or terminated once the test has
begun. As a result, no buttons are active during the execution of this
test.
Hole Punch Test
The media is fed from the default paper source. After selecting a
destination bin, the printer feeds eight pieces of media, hole
punches them, and feeds them to bin 1. The printer prints an
alignment pattern during this test. Go to
Printer" on page
The staple test cannot be canceled or terminated once the test has
begun. As a result, no buttons are active during the execution of this
test.
3-18
Service Manual
1-86.
"Aligning the Finisher and