Fan Modes; Offsets; Changing Settings By Dmx - GLP Highlander Wash User Manual

German Light Products

Fan modes

Two cooling fan modes let you give priority to lowest fan noise or most powerful cooling:
● Regulated sets fans to operate only at the speed that is necessary to cool the fixture
and the lamp. As fixture temperature increases, temperature regulation increases fan
speed to the level that is necessary.
● High speed mode suits operation in high ambient temperatures. Fans are set to
constant operation at high speed. You can use High speed mode to cool down a
fixture quickly after dousing the lamp or to help remove dust from cooling fans.
You can set the cooling fan mode using the control panel or the Special/Control DMX
channel.
In both fan modes, if fixture temperature reaches a dangerous level the fixture will
protect itself from damage by carrying out an emergency lamp shutdown. The
message HEAT will appear in the display and it will be impossible to restrike the lamp until
the temperature has fallen to a safe level.

Offsets

You can customize the Highlander Wash by creating offsets in the fixture's effects,
including pan and tilt. Custom offsets let you adjust fixtures in multiple installations to
compensate for the different positions of the fixtures in the rig, for example.
Custom offsets are for temporary adjustment of individual effects. They are not
permanent fixture calibration values. Custom offset values are reset to zero if you apply
a Service  Advanced  Factory Backup command in the control panel. If you need
to adjust fixture calibration values, please contact GLP Service.

Changing settings by DMX

The Special/Control DMX channel lets you change fixture settings, power the lamp
on/off and perform a fixture reset from the control desk. To apply a command on this
channel you must hold the command for the time indicated in the DMX channel index
section at the end of this manual.
Hilghlander Wash User Manual
®
11