First Startup - Burmester 077 Owner's Manual

CAUTION: Before connecting the unit, please check if the input voltage data on the rear panel, underneath the AC
mains terminal (32) is equal to the local voltage of your wall outlet.
In case of doubt contact a licensed electrician or your power supply company.
•
With external power supply: Connect both components with the multi-pin power cord. To do this, plug any of
the two ends (watch out for the guided grove) of the cord carefully into the POWER SUPPLY terminal (16) of the
preamp and screw down the connector.
•
With external power supply: Use the same procedure to connect the other end into the POWER SUPPLY
terminal (34) of the power supply unit.
•
Connect your preferred in- and outputs of the preamp with your HiFi system. Please refer to the chapter
CONNECTIONS.
•
Make sure, that the AC mains switch (33) on the rear panel of the 077 or on the external power supply unit is
set to OFF position.
•
Connect the AC power cord into the AC mains terminal (32) and plug it into the wall outlet.
•
Switch the AC mains switch (33) to ON position.
•
With the POWER switch (8) on the front panel the unit is switched on.
•
Detailed information about the manifold functions of the preamp, are available in the following chapters of this
owner's manual.

FIRST STARTUP

7