Input Level; Startup Volume; Input Selection Via Remote - Burmester 099 Owner's Manual

Input level

Startup volume

Input selection via remote

In factory default setting, all inputs have been adjusted to the same gain level. Gain
adjustments of individual inputs may be necessary to avoid large volume jumps
when switching between source components with dissimilar output levels. A perfect
adjustment may not be possible in all cases but the 099 lets you lower or boost the
gain by up to 14dB. This should be sufficient to adjust the inputs for most source
components to an identical level.
When adjusting the input levels we recommend using the loudest source as
reference. Try to boost the other inputs to the same level. Should that not be
possible try incrementally lowering the loudest source.
When opening the menu the last active input will automatically appear as preset
input. As indication the LED to the left of the input will illuminate. To choose a
different input use either the Input selector knob (5) or the ► ◄ buttons on the
remote control.
Once you have selected the desired input you can use the Volume control knob (7)
or the ▲ ▼ buttons on the remote control to adjust the gain. The adjustment range
goes from -14dB to +14dB in 1dB increments.
To exit the menu, simply press the MENU button on your remote.
When the 099 preamplifier is switched on it always starts up with the same volume
level. This startup volume setting can be adjusted from level 01 to a maximum level
of 20. To dial in this menu item use the Input selector knob (5) or press the ► ◄
buttons on the remote until all Input selection LEDs (1) are lit. Now you can use the
Volume control knob (7) or the ▲ ▼ buttons on your remote to change the startup
volume level. The bottom three of the Volume level LEDs (4) indicate the selected
startup volume.
To exit the menu, simply press the MENU button on your remote.
If you would like to change inputs using the STATION+/- buttons or the Numerical
buttons on your remote this option has to be activated in the menu.
Turn the Input selector knob (5) or press the ► ◄ buttons on your remote until the
TUNER LED in the row of Input selection LEDs (1) goes dark while all other LEDs
are illuminated (see chart).
By turning the Volume control knob (7) or by pressing the ▲ ▼ buttons on the
remote you can now activate or deactivate this option. When input selection via
remote has been activated the center LED of the Volume level LEDs (4) is
illuminated.
To exit the menu, simply press the MENU button on your remote.
17