Phase Reversal; Shifting Between Main And Record Level; Display Brightness - Burmester 077 Owner's Manual

Phase reversal

In factory settings the preamp 077 passes incoming signals without phase reversal to the
MAIN and RECORD outputs. If the pin polarity of a reproducer differs from the pin polarity of
power amps or active speakers connected to the output terminals (see also owner `s
manual
by 180˚.
The phase reversal is activated or deactivated by pulling the switch key PHASE/DISPLAY
(11) up, or by longer pressing the DIM button (approx. 2 seconds) on your remote control. If
the phase reversal is activated (180˚), the PHASE LED (2) illuminates.
Every input needs to be preset separately for the MAIN and RECORD level. The presetting
will be maintained.
NOTICE: Please be advised that each input can be reversed separately. A phase
reversal of the outputs is not intended.
Shifting between All presets like input selection, volume, input level, phase shift, volume display etc. are
MAIN and REC level separately selectable. Switching between MAIN and RECORD level is done by moving the
switch key RECORD/PHONES (14) upwards or by shortly pressing the MODE button on
your remote control. When the MAIN/REC LED (5) illuminates, the device is in RECORD
level. If the LED is off, the device is in MAIN level.

Display brightness

By pushing the switch key PHASE/DISPLAY (11) down, or by shortly pressing the DIM
button on your remote control you can adjust the brightness of your display in four steps
from "maximum brightness" to "off".
If modus "off" is chosen, the display illuminates when the device is operated to indicate that
a function is controlled, and dims out after a few seconds.
In modus "off", the device shifts to maximum brightness in SETUP-mode. The display will
stay illuminated until you leave the SETUP-mode.
PINS 2 and 3) there is the possibility to reverse the phase of the according input
13