Punch Regist Loop Size Adjustment - Konica Minolta BIZHUB C203 User Manual

Utility mode
11.8.4

Punch Regist Loop Size Adjustment

When printing with a Punch setting, the angle of punched holes along the side of the paper can be adjusted.
Note
[Punch Regist Loop Size Adjustment] does not appear if optional finisher and punch kit are not installed.
!
Detail
For details on the Punch settings, refer to
0 Before making any adjustments, use a Punch setting to print a sample copy. Perform the adjustment
while checking the sample that was created.
1
Display the Administrator Settings screen.
– For details on displaying the Administrator Setting screen, refer to
Settings screen" on page
2
Touch [1 System Settings].
The System Settings screen appears.
3
Touch [7 Expert Adjustment].
The Expert Adjustment screen appears.
4
Touch [3 Finisher Adjustment].
The Finisher Adjustment screen appears.
5
Touch [4 Punch Regist Loop Size Adjustment].
The Punch Regist Loop Size Adjustment screen appears.
6
Check the angle of the punched holes.
– If the punched holes are angled, touch [+] to change the adjustment. If the angle cannot be adjusted
by touching [+] or if the paper is wrinkled, touch [-] to change the adjustment.
– Each time [+] or [-] is touched, the value is increased or decreased by one increment.
– A range between -4 mm and 4 mm is available for setting.
7
Touch [OK].
– To cancel the setting and select the default, press the [Reset] key.
The angle of the punched holes is adjusted.
If no adjustment of the angle of the punched holes was necessary in step 6, this completes the
procedure.
8
Use a Punch setting to print another sample copy.
C353/C253/C203
"Punching holes in copies (Punch settings)" on page
11-34.
"Displaying the Administrator
11
2-66.
11-54