Utility mode
–
If the lines are shifted in the X direction as shown
below, touch [-] under "X" to reduce the adjustment.
–
Each time [+] or [-] is touched, the value is increased
or decreased by one increment.
–
A range between -6 dots and 6 dots is available for
setting.
–
If the lines are shifted in the X direction as shown
below, touch [+] under "X" to increase the
adjustment.
–
If the lines are shifted in the Y direction as shown
below, touch [-] under "Y" to reduce the adjustment.
–
If the lines are shifted in the Y direction as shown
below, touch [+] under "Y" to increase the
adjustment.
–
If the lines are not shifted from the reference lines, continue with step 10.
9
Press the [Start] key.
–
The adjustment is applied when the [Start] key is pressed. To cancel the adjustment, press the
[Reset] key instead of pressing the [Start] key.
The adjusted test pattern is printed.
10
Check the print result.
–
If there is no shift between the black and cyan lines, continue with step 11.
–
If more adjustment is necessary, repeat steps 8 and 9.
C353/C253/C203
11
11-57