Konica Minolta BIZHUB C203 User Manual page 484

Utility mode
– If the saddle stitcher is installed on optional finisher FS-519, touch buttons for the paper size and
for the paper type.
If the paper size to be adjusted is not displayed, touch [↑] and [↓] until the desired paper size is
–
displayed.
6
Compare the width of the left pages of the copy sample with the width of the right pages to check for
the center of the paper.
– If the staple position is too far to the left of the center of the paper, touch [+] to increase the
adjustment.
– Each time [+] or [-] is touched, the value is increased
or decreased by one increment.
– With Finisher FS-519, a range between -10 and 10 is
available for setting.
– With Finisher FS-609, a range between -7 mm and 7
mm is available for setting.
– If the staple position is too far to the right of the center
of the paper, touch [-] to reduce the adjustment.
7
Touch [OK].
– To cancel the setting and select the default, press the [Reset] key.
The stapling position is adjusted.
If the stapling position was at the center of the paper in step 6, this completes the procedure.
8
Use the "Center Staple & Fold" setting to print another sample copy.
9
Check the print result.
– Check that the stapling position is adjusted to the center of the paper.
– If more adjustment is necessary, repeat steps 5 through 8.
C353/C253/C203
Finisher FS-609
11
11-49