Performing Apreset Switch - PESA Cougar 3 User Manual

When you select a source key, input signals defined through the source group assigned to the
source number key are routed to destination outputs on only the switching levels defined for the
breakaway switch. When a source is selected, the pushbutton lights and the switch immediately
occurs.
Using example devices from paragraph 4.4, if you wish to route video from NET1 and audio
from REC1 to VTR1, perform the following steps:
Press the Destination Select key, the button lights.
-
Press the number key assigned to destination group VTR1, in this example OUT1.
-
Press the Source Select key, the button lights.
-
Press level key 1 to select the VID level for breakaway, the button lights.
-
Press the number key configured to source group NET1, in this example IN1, the button
-
lights.
Press level key 1 a second time to de-select VID level, the button is not lit.
-
Press level keys 2 and 3 to select switching levels AUD1 and AUD2 for breakaway, the
-
buttons light.
Press the number key configured to source group REC1, in this example IN2, the button
-
lights.
Press level keys 2 and 3 a second time to de-select breakaway and return the panel to
-
AFV operation.
4.10.3 P
ERFORMING A
Preset switching mode is active when the PRESET button is illuminated – and remains the active mode
of the panel until the button is pressed again to cancel. Preset may be used for All-Levels or Breakaway
switches and allows you to pre-define a switch operation and execute the switch, when needed, by
pressing the TAKE button. Follow steps below to perform a breakaway switch:
•
Select Desired Output Destination:
Press the DESTINATION select key on the local control panel, the button will light.
Press the number key (1 – 32) corresponding to the destination group for which you wish to
configure a preset switch, for example OUT1 corresponds to key 1; now both the DEST key and
the selected number key should be lit.
•
Place Panel in PRESET Switching Mode:
Press the PRESET pushbutton on the panel, the key illuminates and the number key select
function (Dest./Source) changes to Source. The Source Select button lights and the number key
corresponding to the source currently routed to the destination you selected in the previous step
also lights.
Proprietary Information of PESA
PRESET S
WITCH
C 3 V
OUGAR
Publication 81-9059-0660-0, Rev. B
R
IDEO OUTER
March 2011
4-11