Control Panel/Controller Interconnection; Figure 2–2 Dip Switch Location - PESA RCP-48X Manual

RCP-48X
2.4 Polling Address (Device Number) Continued:

2.5 Control Panel/Controller Interconnection

Each panel has a single 3-pin MTA connector located on the rear panel.
Control panels are daisy chained to a port on the rear of the Controller.
Use shielded twisted pair cable. See Figure 2–3.
CONTROLLER
Figure 2–2 DIP Switch Location
P S
P S
Control
Panel
(TWISTED PAIR)
(TWISTED PAIR) - TO CP'S
(TWISTED PAIR) - TO CP'S
(TWISTED PAIR) - TO CP'S
CP = Control Panel
Figure 2–3 Typical Control Panel Controller Interconnection
Installation
P S
Control
Control
Panel
Panel
Section 2
P S
Control
Panel
TERMINATE AT THE
THE END OF THE RUN
(120 OHM RESISTOR)
page 2.3
2
INSTALLATION