Install Rear Support Rails; Figure 3-1 Rear Rack Rail Kit - PESA Cougar 3 User Manual

•
Install bottom two panel-mounting screws through holes in frame mounting bracket.
•
Install top two screws.
•
Tighten all panel-mounting screws until secure.
•
If no local control panel is used, replace front cover on frame by aligning captive screws with
captive nuts on frame mounting brackets and secure by tightening thumb screws.
•
Before replacing local control panel on video routing frame, re-attach power and Ethernet
cables to connectors on rear of panel. You may attach the Ethernet cable from the router to
either connector 1 or 2 on the control panel.
3.2 I R
NSTALL EAR
Your Cougar3 router is shipped with a Rear Rack Rail Kit. It is important that this kit be installed as part
of the mounting procedure for the frame. Major components included with the kit are shown in Figure 3-
1. Each kit consists of two rear rack rails, two rail mounting ears and four screws (not shown) to attach
rails to the frame.

Install Rear Support Rails

•
Mount router frame in equipment rack
and secure chassis.
•
Install one Rear Rack Rail to chassis at
the two Rack Rail Attachment Points
using two Mounting Screws as shown
at right.
Proprietary Information of PESA
S R
UPPORT AILS

Figure 3-1 Rear Rack Rail Kit

Rear Rack Rail (2)
Rail Mounting Ear (2)
Rack Rail
Attachment Points
Rear Rack Rail
• Repeat on opposite side of chassis using
second rack rail and remaining two
mounting screws.
• Figure at left shows rear of chassis with
both rack rails installed.
C 3 V
OUGAR
Publication 81-9059-0660-0, Rev. B
1RU Chassis
Mounting Screws
R
IDEO OUTER
March 2011
3-2