Configuring Automatic Restart
Configuring Automatic Battery Tests
To configure the automatic battery tests:
1.
From the main menu, press the down (
Configuration menu, and press the OK button.
2.
Press the down (
B
press the OK button.
3.
Press the down (
B
the automatic battery test.
4.
Press the OK button for 1 second to confirm.
The UPS automatically restarts if the utility power returns after the
output was shut off because of depleted batteries, a shutdown input
signal, or an automatic shutdown command.
You can set the load segment for the amount of time to delay the restart
when utility power returns by using the Automatic Start Delay setting (see
Table 4 on page 26).
Eaton 9910 UPS and EBM User's Guide
B
) button to scroll to Automatic Battery Tests, and
) button to select whether to enable or disable
OPERATION
) button to scroll to the
S
P-164000005 Rev 2
35