Configure Measurement Instruction; Display Subsystem - Agilent Technologies Agilent 86120B User Manual

Programming Commands

CONFigure Measurement Instruction

Note
Only one STATe command can be turned on at any one time. Attempting to turn more
than one state on at a time results in a "–221 Settings Conflict" error.
delta, drift, and signal-to-noise" on page 4-14
measurements.
CONFigure Measurement Instruction
For information on the CONFigure measurement instruction,
surement Instructions" on page

DISPlay Subsystem

The commands in this subsystem have the following command hierarchy:
:DISPlay
:MARKer:
:MAXimum
:LEFT
:NEXT
:PREVious
:RIGHt
[:WINDow]
:GRAPhics
:STATe
5-64
for additional information on selecting
5-15.
Refer to "Measure
refer to "Mea-