Step 3. Connect The Line-Power Cable - Agilent Technologies Agilent 86120B User Manual

W A R N I N G
C A U T I O N
C A U T I O N
C A U T I O N
1 Verify that the line power meets the requirements shown in the following table.
2 Connect the line-power cord to the instrument's rear-panel connector.
Getting Started

Step 3. Connect the Line-Power Cable

Step 3. Connect the Line-Power Cable
This is a Safety Class 1 Product (provided with a protective earthing
ground incorporated in the power cord). The mains plug shall only be
inserted in a socket outlet provided with a protective earth contact.
Any interruption of the protective conductor inside or outside of the
instrument is likely to make the instrument dangerous. Intentional
interruption is prohibited.
Always use the three-prong AC power cord supplied with this instrument.
Failure to ensure adequate earth grounding by not using this cord may cause
instrument damage.
Do not connect ac power until you have verified the line voltage is correct as
described in the following paragraphs. Damage to the equipment could result.
This instrument has autoranging line voltage input. Be sure the supply voltage
is within the specified range.
Line Power Requirements
Power: 115 VAC: 110 VA MAX. / 60 WATTS MAX. / 1.1 A MAX.
230 VAC: 150 VA MAX. / 70 WATTS MAX. / 0.6 A MAX.
Voltage nominal: 115 VAC / 230 VAC
range 115 VAC: 90-132 V
range 230 VAC: 198-254 V
Frequency nominals: 50 Hz / 60 Hz
range: 47-63 Hz
1-6