A4 Fuser - Lexmark MX71x Service Manual

A4 Fuser

The A4 fuser cannot fuse the entire right side of any print job that uses media wider than 8.27" (for example: letter or
legal). You can use the A4 Fuser setting to determine whether these images are clipped or compressed. Compression
is only in the X direction; scaling does not apply to the process (or Y) direction.
To change the setting:
1
From the Configuration menu, navigate to A4 Fuser.
2
Select from the available options to change the setting.
•
Compress
• Clip
3
Depending on the printer model, press OK or touch
Menu without saving any changes.
Require Standby
Note: This setting is available on the touch screen models only.
This setting determines whether Standby Mode is On or Off. The default is On.
To change the setting:
1
From the Configuration Menu, navigate to Require Standby.
2
Select On or Off to change the setting.
3
Depending on the printer model, press OK or touch
Menu without saving any changes.
If Standby Mode is On, the printer begins functioning in Standby Mode when it remains idle for an amount of time.
The Standby Mode enables the printer:
•
To consume less energy than when operating in normal mode but not as little as when operating in Power Saver.
• To return to the Ready state more quickly than when operating in Power Saver. If set to Off, this setting disables
Standby Mode in the General Settings Menu.
A5 Loading
This determines the orientation used when printing on A5 paper.
Available options:
•
Long Edge—The printer will print A5-size paper in the long-edge feed orientation from all trays.
• Short Edge—The printer will print A5-size paper in the short-edge feed orientation from all trays.
to save the setting, or press X to return to the Configuration
to save the setting, or press X to return to the Configuration
Service menus
365
7463