Dascom 2610 User Manual page 58

Tally Dascom 2610
SerialN factory set
AssetN 10 digits empty
GrSpeed GrSpeed=Normal
GrSpeed=High
Jobcntl Jobcntl=On
Jobcntl=Off
UltraDr UltraDr=on
UltraDr=off
a width of 13 mm or more as the
right-hand paper edge.
If the sensor does not detect any
black area, the maximum possible
printing width is used as the printable
area.
With the SerialN function you have the
possibility to change the 12 digit serial
number of the printer. The number can
be written with any ASCII character
between hex 20 and hex 7E.
LED Panel: The Serial Number cannot
be set via menu instead you need to use
the WebPanel.
With the AssetN function you have the
possibility to change the 10 digit asset
number of the printer. The number can
be written with any ASCII character
between hex 20 and hex 7E.
LED Panel: The Asset Number cannot
be set via menu instead you need to use
the WebPanel.
This parameter allows improved Graphic
Speed independently to the driver. It
affects only the print speed of graphic
printouts at 180 x 180 dpi.
This parameter activates the printer
language PJL (Printer Job Language) in
connection with the internal Ethernet
interface (ETH-INT) or the external
TallyCom III interface (ETH-EXT) .
Ultra Draft=on, speeds up 17.1 and 20
cpi. Precondition is HS-Draft needs to be
activated.
45