2-8-4
OPTIONAL UNIT INSTALLATION
General
The IC-F3062 series transceiver can be installed with
one of the following optional units.
· UT-109R/UT-110R VOICE SCRAMBLER UNIT Non-
rolling type (UT-109R)/Rolling type (UT-110R) voice
scrambler unit provides higher communication security.
· UT-119 DIGITAL MODULATOR/DEMODULATOR UNIT
Provides 6.25/12.5 kHz narrow bandwidth digital mode
operation.
Installation
CAUTION!
Optional unit installation should be done at authorized
Icom service centre only.
The water-resistance capability of the transceiver cannot
be guaranteed if you install an unit yourself, or have it
done at a non-authorised dealer/service centre.
Install the optional unit as follows.
① Rotate [VOL] to turn the power OFF, and remove the
battery pack.
② Remove the antenna and antenna nut
③ Remove the rotary selector
④ Unscrew two screws
Ⓓ
from the front panel in the direction of the arrow.
BE CAREFUL!
Flat cable is connected between the MAIN unit on the
chassis and front panel.
⑤ Install the optional unit as below.
• UT-96R, UT-109R and UT-110R installation
DO NOT attach the unit to the connector "J2."
Otherwise no TX modulation or AF output is available.
* The PC board modification is required when installing
optional UT-109R and UT-110R.
Optional Internal Unit
.
Ⓐ
and volume control
Ⓑ
, then take off the chassis
• UT-119 installation
DO NOT attach the unit to the connector "J1."
Otherwise no TX modulation or AF output is available.
• The PC board modification for UT -109R and UT-110R
installation
Cut the pattern on the PC board at "MIC" and "AFOUT" as
shown below..
.
Ⓒ
NOTE: When uninstalling the unit
Be sure to re-solder the disconnected points as below
when you remove the unit.
Otherwise, no TX modulation or AF output is available.
19