Table of Contents
Advertisement
6
OPTIONAL UNIT INSTALLATION
I Optional unit installation
Install the optional unit as follows:
q Rotate [VOL] to turn the power OFF, and remove the bat-
tery pack. (p. 2)
w Remove the unit cover.
NOTE: Use a flat head screw driver or a similar flat instrument,
and insert into the hollow of the chassis, then lift and take away
the unit cover. (The removed cover cannot be used again.)
e Install the unit as shown below.
r Replace the unit cover and the battery pack, then rotate
[VOL] to turn the power ON.
30
NOTE: The optional UT-109/UT-110
UT-117 (scrambler version) requires some PC board mod-
ifications. Please refer to the additional installation as at
right.
*This illustration is
described with the
UT-113.
or
SCRAMBLER UNITS
Advertisement
Table of Contents
