Icom IC-F4062S Sales Handbook page 38

Program setting for scrambler
Non-rolling-type voice
scrambler UT-109R
Memory CH - Scrambler
• ON/OFF
Turn voice scrambler function ON or OFF as an initial
setting.
OFF : Turn the voice scrambler function OFF.
ON : Turn the voice scrambler function ON.
Inh : The voice scrambler function selection for the
user is inhibited.
• Type
Select the desired voice scrambler type from UT- (UT-
109/110), Inv (Inversion) or Oth (Other-T).
UT- : The optional UT-109R/UT-110R VOICE
SCRAMBLER UNIT.
Inv : Internal voice scrambler is set to Inversion.
Oth : Other voice scrambler unit.
• Code
Program scrambler codes.
Available codes;
Non-rolling type (UT-109R): 1 to 32
Rolling type (UT-110R): 1 to 255
*Set the voice scrambler type as Rolling or Non-rolling in
Common screen.
Oth: 1 to 16
Inv: The code setting will be invalid.
NOTE:
- The optional UT-110R or UT-109R VOICE SCRAMBLER
UNIT is required.
- Set the voice scrambler type as Rolling or Non-rolling in
Common screen.
- Set the scrambler group code in the Common screen in
advance.
Voice Scrambling Systems
Rolling type voice
scrambler UT-110R
Common - Scrambler
• Type
Set installed voice scrambler type as UT-110R Rolling or
UT-109R Non-rolling.
As Rolling type and Non-rolling type have different code
settings, they are not compatible.
By selecting Non-rolling type in this item, you can use
the UT-109R, or UT-110R as Non-rolling type.
Selectable value: Rolling or Non-rolling
NOTE:
1. This item is invalid for frequency inversion type.
2. When Non-rolling type is selected, the following
setting will be invalid.
• Group Code
Set the Scrambler Group code number.
Available number: 1 to 4
NOTE: This item is invalid for frequency inversion type
and Non-rolling type.
• Synchronous Capture
"Synchronous capture mode" is useful when
communicating through a repeater.
However, because of voice components, the transceiver
cannot maintain synchronous mode in rare cases.
Normally it is best to set this item to "Standard".
Selectable value: Standard (normal operation) or
Continuous (repeater operation)‫‏‬
NOTE: This item is invalid for frequency inversion type
and Non-rolling type.
• Tone Start Timing
Tone start timing selects the synchronous tone signal
transmission delay time.
Set the delay time when the other party's transceiver
has power save mode.
Selectable value: OFF (default), 300 ms, 600 ms and
1100 ms.
NOTE: This item is invalid for frequency inversion type
and Non-rolling type.
38