Setting Power Saving Functions - Sony PDW-850 Operation Manual

2
Move the b cursor to the item to set
using the MENU knob, and press the
MENU knob.
The EDIT FUNCTION page appears.
EDIT FUNCTION
INSERT
MOVE
DELETE
BLANK
3
Select INSERT, and press the MENU
knob.
?P00 CONTENTS
01.OUTPUT 1
02.OUTPUT 2
03.SUPERIMPOSE
04.LCD
05.REC FUNCTION
06.ASSIGNABLE SW
07.POWER SAVE
08.VF DISP 1
09.VF DISP 2
10.VF DISP 3
4
Add an item as follows.
1 Press the MENU knob, scroll the page
until the desired page appears, and then
press the MENU knob.
2 Press the MENU knob again, select the
desired item, and then press the MENU
knob.
The EDIT ASSIGN SEL page appears again,
displaying the added item.
5
Repeat steps 2 to 4 to add the remaining
items.
You can register up to ten items.
Operation of the ASSIGN 1/2/3/4 switches when
UA01 to UA10 are assigned
When an on/off switchable function (or menu
item) is assigned to one of the ASSIGN 1/2/3/4
switches, each time the switch is pressed toggles
the function on or off.
When another type of menu item is assigned,
pressing the switch displays the item and its
setting value on the viewfinder screen.
You can then change the setting by pressing and
turning the MENU knob.
The viewfinder screen display disappears
approximately three seconds after the last
operation.
212 Adjustments and Settings from Menus

Setting power saving functions

You can limit the function of some output
connectors to save power consumption.
(How to select an item in the menu screen: Turn
ESC
the MENU knob to move b to the desired item.)
1
Display the POWER SAVE page of the
OPERATION menu, and press the
MENU knob.
For details on menu operations, see "Basic
menu operations" (page 193).
2
Select the desired item, and press the
MENU knob.
You can set the following items on the
TOP
POWER SAVE page.
Item
ETHERNET/
USB
REC AUDIO
OUT
TEST OUT
SAVE
Wi-Fi
a) The unit must be powered off and on again to
enable changes to this setting.
3
Turn the MENU knob to select the
desired setting, and press the MENU
knob.
4
Repeat steps 2 and 3 until you have set
all of the desired items.
Description
Enables or disables the
network connector and USB
connector.
Puts the AUDIO OUT
connectors in EE or SAVE
mode.
Switches the TEST OUT
connector power saving
function on and off.
ON: No signals are output if
a cable is not
connected.
OFF: Signals are always
output, regardless of
whether a cable is
connected.
Enables or disables the
wireless LAN function.