Distributor Calibration; Sampler Cleaning Guidelines - Teledyne 5800 Installation And Operation Manual

Isco 5800 Refrigerated Sampler
Section 5 Maintenance
Figure 5-3 Wetted Parts

5.1.6 Distributor Calibration

5.1.7 Sampler Cleaning
Guidelines
5-6
For application-specific requirements, consult with your
laboratory to establish cleaning or replacement protocols.
A
A. Strainer (316 stainless steel,
polypropylene, or CPVC)
B. Suction Line (vinyl)
C. Tubing Coupler
(316 stainless steel)
D. Pump Tube (silicone)
The Test Distributor Diagnostic calibrates the samplers dis-
tributer alignment. Specify the bottle position to which the
sampler should move the arm, then verify the correct positioning
of the arm.
Note
This test is not applicable for samplers configured for operation
with a single 20 liter bottle.
Keeping the sampler clean and protected from harsh elements
may extend the usable life of the sampler. When necessary, clean
the exterior and interior of the sampler with warm soapy water
and brush, then rinse with water. Be sure to use a detergent that
is compatible with low-density polyethylene, polystyrene, PVC,
ABS, polycarbonate and NORYL™
and acids.
1. NORYL is a registered trademark of SABIC Innovative Plastics
IP B.V.
C
E
B
G
E. Bulkhead Fitting (316 stain-
less steel)
F. Discharge Tube (silicone)
G. Bottle (glass, polypropylene,
or polyethylene)
1
. Avoid using strong solvents
D
F