Figure 2-8 Attaching the suction line to the pump tubing
2.6.2 FEP-lined Suction Line
Figure 2-9
Connecting FEP-lined suction line (A) to pump tube (B)
1.
2.
Once the coupler is attached to the pump tube, removal is
difficult, and may require cutting the tube.
Inserting a tube coupler into FEP-lined suction line will damage
the thin lining. Instead, refer to Figure 2-9 and the instructions
below to attach FEP-lined suction line to the pump tube:
1. Slide a suitable clamp over the pump tube inlet.
2. Push about 20 mm of the FEP-lined suction line into the
end of the pump tube.
3. Slide the clamp over the union and tighten. Do not
overtighten the clamp; this might cause the tubing to
collapse or restrict the flow.
A
Isco 5800 Refrigerated Sampler
Section 2 Installation
B
2-15