4, 20L (5 Gal) Bottles; Bottle - Teledyne 5800 Installation And Operation Manual

Isco 5800 Refrigerated Sampler
Section 2 Installation

2.5.5 4, 20L (5 Gal) Bottles

Figure 2-6 Four-bottle, 20L locating base: Bottle mouth placement

2.5.6 1 Bottle

10 liter bottle
2-12
1. Place the four bottles in the locating base with the bottle
mouths positioned above the holes in the base.
2. Slide the locating base into the bottom of the refrigerated
compartment. The arrow must point toward the back of the
refrigerator.
Note
The discharge tube for this configuration must be entered
during programming as a custom length of 17.5" (445mm).
Refer to Section 3.3.2.
Note
Bottles caps can be stored between the bottles.
If your one-bottle configuration has a 10 liter (2.5 gallon)
polyethylene, glass, or ProPak bottle, use a locating base to hold
and align the bottle. If your one-bottle configuration has a 20
liter (5 gallon) glass or polyethylene bottle, simply place the
bottle in the center of the refrigerator; no rack or locating base is
required.
Refer to the instructions for your bottle size.
To install the locating base and 10 liter bottle:
1. Insert the bottle into the hole numbered "1" in the locating
base.
2. Slide the locating base into the bottom of the refrigerated
compartment (Figure 2-5). Note that the arrow must be
pointing toward the back of the refrigerator.
When the sampler controller is configured for a single 10 liter
bottle (section 3), samples will only be distributed to bottle 1. If
CAUTION