Getting Started - Teledyne 5800 Installation And Operation Manual

Isco 5800 Refrigerated Sampler
Section 3 Programming

3.2 Getting Started

3-2
Table 3-1 Control Button Functions
Icon Name Description
Power Places the sampler in the On or Standby modes.
Note: In either modes, mains power is always con-
nected to the refrigeration system.
Numbers Types a number.
Pump At the Main menu, press this button to run the pump
Reverse in the reverse direction to purge the suction line. In
(Purge) other menus, press this button to type the number 1.
Pump At the Main Menu, press this button to run the pump
Forward in the forward direction to fill the suction line. In other
(Fill) menus, press this button to type the number 3.
Previous Selects the previous menu option left or above the
current choice.
Next Selects the next menu option right or below the cur-
rent choice.
Stop, Stops the pump or distributor. Pauses a running
Cancel, sampling program. In programming screens, returns
or Exit to the previous programming level.
Calibrate Press this button from the Main Menu to enter the
Calibration mode.
Grab Press this button from the Main Menu or the Paused
Sample state to take a grab (manual) sample.
Enter Accepts a menu choice or number entry and goes to
next screen.
Run Press this button to start the sampling program.
Program
Apply power to the sampler (see section 2.4). The start-up screens
appear on the LCD display.
Copyright 2006 – 2015
COMPRESSOR WARM-UP!
Note
The refrigeration system may not operate for 45 minutes after
applying power. This delay allows time for the compressor
heater to drive off any refrigerant dissolved in the compressor
oil.After completing the start-up routine, turn the sampler on by
TELEDYNE ISCO
COOLING IN: 44:45
5800 SAMPLER