Section 2 Installation; Unpacking The Sampler; 5800 Sampler Installation Overview; Positioning The Sampler - Teledyne 5800 Installation And Operation Manual

Isco 5800
Refrigerated Sampler

Section 2 Installation

2.1 Unpacking the
Sampler
2.2 5800 Sampler
Installation Overview
2.3 Positioning the
Sampler
In this section...

• Unpacking the Sampler

• 5800 Sampler Installation Instructions
Carefully unpack the shipment and locate the packing list. Verify
receipt of all components against this packing list. If there is any
damage to the shipping carton or any components, contact the
s h i p p i n g a g e n t a n d Te l e d y n e I s c o ( o r i t s a u t h o r i z e d
representative) immediately.
If there is any evidence that the sampler has been damaged
in shipping, do not plug it into an AC power source. Contact
Teledyne Isco or its authorized representative for advice.
Compare the contents of the boxes with the enclosed
packing slip. If there are any shortages, contact Teledyne
Isco immediately.
The following sections provide general instructions for placing
the sampler into operation. In typical applications, the steps are:
1. Position the sampler. (Section 2.3)
2. Connect power. (2.4)
3. Install a bottle kit. (2.5)
4. Attach the suction line. (2.6)
5. Attach a strainer. (2.7)
6. Route the suction line and strainer. (2.8)
7. Connect external instruments. (2.9)
8. Configure and program the sampler. (2.10)
9. Lock the sampler. (2.11)
There are a few considerations when selecting a site for the
sampler. The foremost concern should be personal safety.
The installation and use of this product may subject you to
dangerous working conditions that can cause you serious
or fatal injuries. Take any necessary precautions before
entering the worksite. Install and operate this product in
accordance with all applicable safety and health
regulations, and local ordinances.
WARNING
WARNING
2-1