One 20 Liter Bottle Configuration With Discharge Tube Through The Bottle Cap - Teledyne 5800 Installation And Operation Manual

20 liter bottle
Figure 2-7 One 20 liter bottle configuration with discharge tube
through the bottle cap
you place the bottle in any other position liquid will miss the
bottle.
To install the 20 liter bottle:
The distributor arm should be removed to prevent it from being
an obstruction while you replace the bottle. To remove the arm:
1. Remove the knurled nut that secures the distributor arm.
2. Pull the distributor arm downward to remove it from the
keyed shaft.
3. Store the arm in a safe location for future use.
Then install the bottle:
4. Screw the cap with a hole onto the bottle (PE only).
5. Place the bottle in the center of the refrigerator.
6. Feed the discharge tube into the hole (PE only) (see Figure
2-7).
7. Connect the other end of the discharge tube to the
bulkhead fitting at the top-front corner of the refrigerator.
The discharge tube must slope downward from the
bulkhead fitting to the bottle. Otherwise, liquid might pool
in the tube and cross-contaminate samples.
Note that the discharge tube has a natural curve. Should
the tube create a low spot where liquid can pool, twist the
end of the tube connected to the bulkhead fitting so that
the natural curve holds the tube in a downward sloping
position.
Isco 5800 Refrigerated Sampler
Section 2 Installation
2-13