Configuring Via Terminal - Toshiba RemotEye III User Manual

Configuring via Terminal

The RemotEye III can be configured via a Terminal Emulator Software.
Hardware Setup
Direct configuration is accomplished through the provided RJ45 to DB9 female connector PC cable. Follow these
steps to setup the hardware for direct RemotEye III configuration (See Figure 15: Serial Communication Physical
Connection Example):
1. Connect the DB9 female end of the PC cable to the terminal or workstation COM port. NOTE: if no COM
port is available, use a USB-to-Serial (RS-232) converter.
2. Connect the RJ45 end of the PC cable to the COM port of RemotEye III.
Figure 15: Serial Communication Physical Connection Example
Software Setup
The direct communication can be performed from a workstation that is running a Terminal Emulator Software
(TES) such as HyperTerminal. The direct configuration is accomplished by RS232 communication protocol. If a
Terminal Emulator Software is not available, download "Tera Term" from the internet for free. The serial
communication settings are discussed in the next section.
RemotEye III User Manual – 62330-005
RJ45 End
RJ45 to DB9
Female
Cable
DB9
Female End
21