Safety Instructions - EWM TAURUS 355 Basic TDM Operating Instruction

Safety instructions

Safety instructions
2.3 Safety instructions
Risk of accidents due to non-compliance with the safety instructions!
Non-compliance with the safety instructions can be fatal!
•
Carefully read the safety instructions in this manual!
•
Observe the accident prevention regulations and any regional regulations!
•
Inform persons in the working area that they must comply with the regulations!
Risk of injury from electrical voltage!
Voltages can cause potentially fatal electric shocks and burns on contact. Even low
voltages can cause a shock and lead to accidents.
•
Never touch live components such as welding current sockets or stick, tungsten or wire
electrodes!
•
Always place torches and electrode holders on an insulated surface!
•
Wear the full personal protective equipment (depending on the application)!
•
The machine may only be opened by qualified personnel!
Hazard when interconnecting multiple power sources!
If a number of power sources are to be connected in parallel or in series, only a
technical specialist may interconnect the sources as per standard IEC 60974-9:2010:
Installation and use and German Accident Prevention Regulation BVG D1 (formerly VBG
15) or country-specific regulations.
Before commencing arc welding, a test must verify that the equipment cannot exceed
the maximum permitted open circuit voltage.
•
Only qualified personnel may connect the machine.
•
When taking individual power sources out of operation, all mains and welding current leads
must be safely disconnected from the welding system as a whole. (Hazard due to reverse
polarity voltage!)
•
Do not interconnect welding machines with pole reversing switch (PWS series) or machines
for AC welding since a minor error in operation can cause the welding voltages to be
combined, which is not permitted.
8
WARNING
WARNING
099-005221-EW501
05.09.2016