Information In This Chapter; Conventions Used For Hardkeys, Softkeys, And Menu Items; Chapter Three At-A-Glance - Keysight N5227A Service Manual

Tests and Adjustments

Information in This Chapter

Information in This Chapter
This chapter contains procedures to help you check, verify, and adjust your PNA.
• The checks verify the operation of the assemblies in your analyzer.
• The verification compares the operation of your analyzer to a gold standard.
• The adjustments allow you to tune your analyzer for maximum response.

Conventions Used for Hardkeys, Softkeys, and Menu Items

The following conventions are used in this document:
Hardkey
Softkey
Menu Item

Chapter Three at-a-Glance

Section Title
Before You Begin
About System Verification
and Performance Tests
ANSI/NCSL Z540.3–2006
and ISO/IEC 17025
Verification
Non-Standards Compliant
Verification
3-2
This represents a "hardkey", a key that is physically located on the
instrument.
This represents a "softkey", a key whose label is determined by the
instrument firmware.
This represents an item in a drop-down or pop-up menu.
Summary of Content
Items to consider or procedures to perform before testing is begun:
• Verify the Operating Environment
• Protect Against Electrostatic Discharge (ESD)
• Allow the Analyzer to Warm Up
• Review the Principles of Connector Care
Descriptions of:
• System Specifications
• Instrument Specifications
• System Verification Procedure
• Performance Tests
• Certificate of Calibration
The ANSI/NCSL Z540.3-2006 and ISO/IEC 17025 process of
verifying your analyzer.
The Non-Standards Compliant process of verifying your analyzer.
PNA Series Microwave Network Analyzers
Service Guide N5227-90001
N5227A
Start Page
Page 3-4
Page 3-6
Page 3-8
Page 3-9