Using Ppcbug - Motorola MVME2301 Installation And Use Manual

26. Verifies the configuration data that is resident in NVRAM,
27. Calculates and displays the MPU clock speed, verifies that
28. Displays the BUS clock speed, verifies that the BUS clock
29. Probes PCI bus for supported network devices.
30. Probes PCI bus for supported mass storage devices.
31. Initializes the memory/IO addresses for the supported PCI
32. Executes Self-Test, if so configured. (Default is no Self-Test.)
33. Extinguishes the board fail LED, if Self-Test passed, and
34. Executes boot program, if so configured. (Default is no boot.)
35. Executes the debugger monitor (i.e., issues the

Using PPCBug

PPCBug is command-driven; it performs its various operations in
response to commands that you enter at the keyboard. When the
PPC1-Bug prompt appears on the screen, the debugger is ready to
accept debugger commands. When the PPC1-Diag prompt
appears on the screen, the debugger is ready to accept diagnostics
commands. To switch from one mode to the other, enter SD.
What you key in is stored in an internal buffer. Execution begins
only after you press the Return or Enter key. This allows you to
correct entry errors, if necessary, with the control characters
described in the PPCBug Firmware Package UserÕs Manual, Chapter 1.
and displays a warning message if the verification failed.
the MPU clock speed matches the configuration data, and
displays a warning message if the verification fails.
speed matches the configuration data, and displays a
warning message if the verification fails.
bus devices.
outputs any warning messages.
prompt).
PPCBug
PPC1-Bug>
5-5
5