The Backlight; Personalize The Product - Fluke 753 User Manual

753/754
Users Manual

The Backlight

Push  to change the backlight intensity from dim to bright
and back again.  shows at the top of the display when the
backlight is active. Set the Product to turn the backlight off
automatically to keep battery use to minimum. When the
backlight is on and Auto Backlight Off is in operation, a is
shown at the top of the display.
To automatically dim the backlight after a set time:
1. Push s.
2. Push  to move the cursor to the same line
as Auto Backlight Off.
3. Push  or the Choices softkey.
4. Push  to highlight On, then push .
5. To use the timeout period shown on the display, stop
here. Push the Done softkey to exit Setup mode and do
not go on to step 6.
6. To change the timeout period, push  to highlight the
timeout period following Backlight Timeout.
7. Push  or the Choices softkey.
8. Record the choice of timeout period in minutes
(accepted range: 1 to 120 minutes).
9. Push the Done softkey.
10. Push the Done softkey or s to exit Setup mode.
28
info@Fluke-Direct.ca
When the backlight dims, the Product also beeps.

Personalize the Product

Alphanumeric identifiers can be put into the Product to be
shown at power-up and in results that you keep. To install
an identifier:
1. Push s.
2. Push Next Page twice.
3. Push  to move the cursor to the same line as ID.
4. Push  or the Choices softkey. The screen in
Figure 11 is shown.
Figure 11. Personalize the Product
Fluke-Direct
.ca
1.800.868.7495
gks40s.bmp