Communication With A Pc; Maintenance; Battery Replacement; Clean The Product - Fluke 753 User Manual

Communication with a PC

Procedures and results that you have kept can be
uploaded from and downloaded to a PC. A PC, Microsoft
Windows, USB cable (supplied), and Fluke DPCTrack2
application software, or a qualified Fluke partner's
software are required. See the DPCTrack2 Users Manual
for further instructions.

Maintenance

Warning
To prevent possible electrical shock, fire, or
personal injury:
•
Have an approved technician repair the
Product.
•
Do not operate the Product with covers
removed or the case open. Hazardous
voltage exposure is possible.
•
Remove the input signals before you

clean the Product.

•
Use only specified replacement parts.
info@Fluke-Direct.ca
Additional maintenance instructions, including a
calibration procedure and a list of replaceable
parts is available in the 75X Series Calibration

Manual available from the Fluke website.

Battery Replacement

Replace the battery when it no longer holds a charge for
the rated interval. The battery normally lasts for up to 300
charge/discharge cycles. To order a replacement battery,
see "Contacting Fluke" and "User-Replaceable Parts".
Spent batteries should be disposed of by a
qualified recycler or hazardous materials
handler. Contact an authorized Fluke Service
Center for recycling information.
Clean the Product
Clean the Product and pressure modules with a soft cloth
dampened with water or water and mild soap.
To prevent possible damage to the Product,
do not use solvents or abrasive cleansers.
Fluke-Direct
.ca
Documenting Process Calibrator
Communication with a PC
Note
Note
Caution
1.800.868.7495
101