Agilent Technologies N5230A Service Manual page 223

PNA Series Microwave Network Analyzers
N5230A
Removing the Midweb
Refer to Figure 7-18.
1. Disconnect the power cable (item
motherboard.
2. With a T-10 TORX driver, remove the seven midweb mounting screws (item
of the mounting screws are located on the bottom of the chassis. The analyzer must be
placed on its side to access these three screws.
3. Lift out the midweb being careful not to damage any adjacent components.
Figure 7-18 Midweb Removal
Service Guide N5230-90014
Removing and Replacing the Midweb and the B1 Fan
①
) for each of the three fans from the A14 system
Repair and Replacement Procedures
②
). Three
7-41