Agilent Technologies N5230A Service Manual page 27

PNA Series Microwave Network Analyzers
N5230A
Required Service Test Equipment (Cont'd)
a
Equipment
Extender board
T-8 TORX driver
T-10 TORX driver
T-15 TORX driver
T-20 TORX driver
1/4 inch and 5/16 inch open-end
wrench
5/16 inch, open-end torque wrench
(metric equivalent is 8 mm)
1 inch, open-end torque wrench
(metric equivalent is 26 mm)
20 mm, open-end torque wrench
Adjustable antistatic wrist strap
Antistatic wrist strap grounding
cord (5 foot)
Static control table mat and earth
ground wire
Floppy disks
Floppy disks
USB flash ROM drive
a. Unless specified otherwise, equipment listed is required for all analyzer models.
b. P = Performance tests, A = Adjustments, T = Troubleshooting, R = Repair, V = System verification
Service Guide N5230-90014
Critical Specifications
Tools
N/A
0.6 N-m (5 in-lb) setting
0.5, 0.8, and 1.0 N-m
(4, 7, and 9 in-lb) settings
1.5 N-m (14 in-lb) setting
2.4 N-m (21 in-lb) setting
Thin profile
1.1 and 2.4 N-m (10 and 21
in-lb) settings (for semi-rigid
cables)
8.1 N-m (72 in-lb) setting (for
Port 1 and Port 2 connector
nuts)
0.9 N-m (8 in-lb) setting (for
Port 1 and Port 2
measurement connections)
Static Safety Parts
N/A
N/A
N/A
3.5 inch
Miscellaneous
3.5 inch
N/A
General Product Information
Required Service Test Equipment
Recommended Alternate
Model or Part Model
Number Number
E8356-60021 None
N/A N/A
N/A N/A
N/A N/A
N/A N/A
8710-0510 N/A
N/A
N/A
N/A N/A
N/A
8710-1764
9300-1367 None
9300-0980 None
9300-0797 None
Any None
Any None
Any None
b
Use
T
R
T, R
T, R
T, R
A, R
T, R
R
P, A, T
P, A, T
P, A, T
P, A, T
A
A
P, A
2-9