Writing To Nvram; Reading From Nvram; Reboot - DPS Telecom NetGuardian 480 User Manual

Hide thumbs Also See for NetGuardian 480:

Table of Contents

8.11

Writing to NVRAM

Click the Write To Unit button to make changes to NVRAM. The Smart write option only changes configuration

changes made in the most recent T/NG480 session. The Full write option is slower, but will overwrite the entire

database.

Any changes to the NetGuardian 480 configuration will NOT take effect until you click the Write button in the

toolbar and reboot the unit. The Write button will save all changes you have made to the configuration and will

erase any previous settings.

8.12

Click the Read From Unit button to read changes to NVRAM. The Smart read option only reads configuration

changes made in the most recent T/NG480 session. The Full read option is slower, but will read the entire

database.

8.13

If you have made any changes to the T/NG480 configuration, you will be asked if you would like to save these

changes to your PC's hard disk. Click Yes to save all changes made to the configuration. Click No to cancel the

save procedure.

Fig. 42. Writing to NVRAM.

Fig. 43. Reading From NVRAM.

Fig. 44 . Saving device configuration.

Table of Contents

Do you have a question about the NetGuardian 480 and is the answer not in the manual?