Before You Begin - Nexcom PEAK 735 Series User Manual

Table of Contents

Advertisement

This chapter of the User' s Manual describes how to set jumpers.
Note: The procedures that follow are generic for all of the PEAK735 models

Before You Begin

Ensure y ou have a stable, clean working environment. Dust and dirt can get into components and cause a
malfunction. Use containers to keep small components separated.
Adequate lighting and proper tools can prevent y ou from accidentally damaging the internal components.
Most of the procedures that follow require only a few simple tools, including the following:
? A Philips screwdriver
? A flat-tipped screwdriver
? A set of jewelers Screwdrivers
? A groun ding strap
? An anti-static pad
Using y our fingers can disconnect most of the connections. It is recommended that y ou do not use needle-
nosed pliers to disconnect connections as these can damage the soft metal or plastic parts of the
connectors.
Before working on internal components, make sure that the power is off. Ground y ourself before touching any
internal components, by touching a metal object. Static electricity can damage many of the electronic
components. Humid environment tend to have less static electricity than dry environments. A grounding
strap is warranted whenever danger of static electricity ex ists.
Precautions
Computer components and electronic circuit boards c an be damaged by discharges of static electricity.
Working on the computers that are still connected to a power supply can be ex tremely dangerous. Follow
the guidelines below to avoid damage to y our computer or y ourself.
??Alway s disconnect the unit from the power outlet whenever y ou are working inside the case.
??If possible, wear a grounded wrist strap when y ou are working inside the computer case. Alternatively,
discharge any static electricity by touching the bare metal chassis of the unit case, or the bare metal
body of any other grounded appliance.
??Hold electronic circuit boards (such as the PEAK639VL board) by the edges only. Do not touch the
components on the board unless it is necessary to do so. Don' t flex or stress the circuit board.
??Leave all components inside the static-proof packaging that they shipped with until they are ready for
installation.
??Use correct screws and do not over tighten screws.
11

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the PEAK 735 Series and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Table of Contents