Carel PRK300L3FK User Manual page 93

After having answered the questions for the confi guration of the second
suction line, the software then asks if there is a pLAN board dedicated to
condenser line 1. In the case shown in the example, answer NO.
Wizard
Compressor config.
Dedicated pRack
board for
condensing line:
After having confi gured condenser line 1, the software asks if condenser
line 2 is used; answer YES:
Wizard
Configure another
condensing line:
After having confi gured the second condenser line, the software off ers the
option to automatically confi gure the I/Os (choosing YES), as described
in par. 4.1.4. If choosing NO, each individual I/O needs to be confi gured
manually at the end of the wizard. In addition, the software asks the user
whether or not to display a summary of the settings made:
Wizard
Enable I/O config: YES
Visualize Wizard
?
report
(Push [DOWN]
to continue)
If the settings are correct, the set values can be installed:
Wizard
Boards necessary
1
2
All boards present,
(ENTER) to continue
After waiting a few seconds, the unit can be started.
Wizard
Successfully complete
Press (ENTER) to
continue
Note: after having confi gured pRack pR300, the device needs to be
switched off and on again to permanently save the new data.
Ib90
NO
Ib96
YES
Ib2a
NO
Ib3a
93
ENG
pRack +0300025EN rel. 1.3 - 17.12.2015