Set Report Mode; Auto Upload Gps Location To Platform; Shock Control Upload Lbs Location To Platform; Shock Control Upload Gps Location To Platform - Carscop CCTR-800+ User Manual

the tracker will be turned on and locate and then send the location information with Google map link to user by
SMS, again a few minutes later, the tracker will be turned off, and waiting the timer is up and repeat the above
process. The battery power cost is also very low in mode 4, normally this mode is used for checking location
every setting time (For example check one time every day or every hour), and the platform is not necessary,
mobile phone can do this, this mode is not used for real time tracking.
In mode 3 & 4, if no GPS signal, the tracker will report the LBS location, and if the LBS location can not be
got, the tracker will turn off and wait for another weak up.
Note: In mode 3 & 4, if user want to change the setting or operate, only can send the SMS command and
wait for reply, the tracker will receive SMS and operate the command when the tracker weak up after the
setting interval time. Or you can press the button A or B or C to start the tracker immediately.
10. Set Report Mode (Only Suit for System Working mode 1 & 2 )
Send SMS "REPORT*123456*Z" or "302*123456*Z" to the tracker, "REPORT" and "302" are command,
"123456" is password, "Z" is the report mode, it is 0,1,2,3 or4, after receive the command, the tracker will reply
SMS "Report mode set to Z (0 No report, 1 Shock upload GPS, 2 Auto upload GPS, 3 Shock upload LBS, 4
Auto upload LBS)" . The report modes are described below:.
Report Mode 0 ------ Don't Report Location Automatically (Only triggered by SMS or Calling)
Under this mode, the tracker only can be triggered by SMS or calling to located and reply location with
SMS to user, but the tracker will not locate initiative and report location automatically.
Report Mode 1 (Factory Default Mode) ------ Shock Control Upload GPS Location to Platform
This mode is the default working mode, under this mode, when the tracker begin to move and the shock
sensor will be triggered, the tracker will turn on the GPS, after located the tracker will upload the location to
platform every setting interval time
11, for personal using we recommended
tracker will turned off GPS and stop uploading location to platform.
In this mode, if no GPS signal, the tracker will get LBS location and upload to platform, and if the LBS
location can not be got, the setting interval time later, the tracker will begin another locating.
Report Mode 2 ------ Auto Upload GPS Location to Platform
Under this mode, the tracker will turn on the GPS every setting interval time, after located the tracker will
upload the location to platform
for personal using we recommended
turn on the GPS & upload the location to platform every setting interval time.
In this mode, if no GPS signal, the tracker will get LBS location and upload to platform, and if the LBS
location can not be got, the setting interval time later, the tracker will begin another locating.
Report Mode 3 ------ Shock Control Upload LBS Location to Platform
Under this mode, when the tracker begin to move and the shock sensor will be triggered, the tracker will
locate by LBS, and will not turn on GPS to locate, after located the tracker will upload the LBS location to
(default is 30 seconds, time interval setting please refer the following
300-600seconds), if the tracker stop moving, 5 minutes later, the
(default is 30 seconds, time interval setting please refer the following 11,
300-600seconds), wherever the the tracker is moving, the tracker will
-11-