Set System Working Mode; Factory Default Mode; Shock Control On/Off; Cycle On/Off & Upload Location To Server By Gprs - Carscop CCTR-800+ User Manual

"123456" is password, the tracker will send back the information "Set Shock Alarm OFF" to indicate the
operation is success and disable the shock alarm, After disable the shock alarm, the system will not check
shock sensor again.
If the authorized number have been set, use the authorized phone number to send SMS "ALARMON#" or
"789#" or "ALARMOFF#" or "000#" to the tracker also can trigger the tracker to enable or disable shock alarm,
the password is not necessary any more.

9. Set System Working Mode

Send SMS "MODE*123456*X" or "301*123456*X" to the tracker, "MODE" and "301" are command,
"123456" is password, "X" is the working mode, it is 1 or 2, if the "X" is 3 or 4, the SMS command should be
"MODE*123456*X*Y" or "301*123456*X*Y" , "Y" is the sleep time from 01-99, unit is hour. after receive the
command, the tracker will reply SMS "Working mode set to X (1 Working,2 Shock On/Off, 3 Cycle On/Off
GPRS, 4 Cycle On/Off SMS)" . The working modes are described below:.
Mode 1 (Factory Default Mode) ------ Continuously Working (GSM keep working or standby)
This mode is the default working mode. under this mode, the tracker can receive SMS or calling, locate or
not and report by GPRS or SMS is decided by report mode
Mode 2 ------ Shock Control ON/OFF
Under this mode, when the tracker begin to move, the tracker will be turned on, and when the tracker stop
moving 5 minutes, the tracker will be turned off to sleep. When the tracker are turned off, the tracker can not
receive any command, and can not be triggered locating by SMS or calling. Only shock sensor can trigger the
tracker wake up. Also locate or not and report by GPRS or SMS is decided by report mode
following 10).
This mode can save battery power than mode 1, if the tracker stop moving , standby time can reach 2 or 3
times than mode 1 (different according to the GSM & GPS signal working condition).
Mode 3 ------ Cycle ON/OFF & Upload Location to Server by GPRS (Need Platform)
Under this mode, the system ON / OFF is controlled by timer (interval time is Y hours). The tracker will be
turned on and locate with GPS and then upload the location information to server by GPRS, and then a few
minutes later, the tracker will be turned off, and the timer will begin to count, after the time is up, the tracker will
be turned on and locate and then upload the location information to server by GPRS, again a few minutes later,
the tracker will be turned off, and waiting the timer is up and repeat the above process. The battery power cost
is very low in mode 3, normally this mode is used for checking location every setting time (For example check
one time every day or every hour), not used for real time tracking.
Mode 4 ------ Cycle ON/OFF & Report Location to User by SMS (No Platform Necessary)
Under this mode, the system ON / OFF is controlled by timer (interval time is Y hours). The tracker will be
turned on and locate with GPS and then send the location information with Google map link to user by SMS,
and then a few minutes later, the tracker will be turned off, and the timer will begin to count, after the time is up,
(refer the following
-10-
10).
(refer the