Table of Contents
Advertisement
Starting the descaling programme
The cooking compartment must have cooled down
completely.
1
Prepare a descaling solution by mixing 300 ml
water and 60 ml liquid descaler.
2
Set function selector to S. Use the rotary selector
to select the descaling programme.
'
3
The
symbol is displayed. Confirm with
4
Fill the water tank with descaling solution and
slide it into the water tank compartment. Close
the appliance door. Confirm with
5
A descaling time of 30 minutes is displayed. Start
I
with
. The descaling time counts down on the
display. The light in the cooking compartment
remains switched off.
6
A signal sounds after 30 minutes. A message
appears on the display.
7
Empty the evaporator dish with the cleaning
sponge. Fill the water tank with cold water.
™
Confirm with
.
8
The first rinsing process appears. Start with
The appliance is rinsed. The rinsing time counts
down on the display.
9
A signal sounds after one minute. Empty the
evaporator dish with the cleaning sponge.
™
Confirm with
.
10 The second rinsing process appears. Start with
The appliance is rinsed. The rinsing time counts
down on the display.
A signal sounds after one minute. The descaling
programme has finished.
Empty the evaporator dish with the cleaning sponge.
Empty the water tank and leave it to dry with the lid
open. Dry the cooking compartment with a soft cloth
and dry fully with the drying programme.
Then delete the descaling hint in the display.
24
Deleting the descaling hint
1
2
Notes
‒
™
.
‒
‒
™
.
Removing slide-in rails
You can remove the slide-in rails for cleaning.
Detaching the rails
1
2
3
I
.
Clean the rails in the dishwasher.
Attaching the rails
1
2
3
Note: If you should lose a knurled nut, you can order it
as a spare part from our after-sales service. Using
I
.
knurled nuts other than the original ones will cause
corrosion in the oven interior.
Set function selector to S. Use the rotary selector
to select "Delete descaling hint". Confirm with
A notification appears. Confirm with
The descaling programme must always be run
through completely and cannot be cancelled.
Before cooking, remove any descaler residue
from the cooking compartment.
If the descaling programme was cancelled due to
a power cut, it must be restarted before using the
oven again in order to remove any descaler
residues from the appliance.
Place a dishcloth in the cooking compartment to
protect the stainless steel against scratches.
Undo the knurled nuts (Figure A).
Pull away the slide-in rails slightly sideward from
the screw and pull it out toward you (Figure B).
Position the slide-in rails correctly with the
stopper at the back.
Push the slide-in rails onto the bolt at the rear and
then hook them in at the front.
Tighten the knurled nuts.
™
.
™
.
Advertisement
Table of Contents
